Expansion valve ready for reassembly.
| 
Water inlet with one way valve. The little black thing was attached to the bottom plate with onyl two small rivets. That thing also has to carry the considerable weight of the pressure reducer!
| 
Water inlet with micro filter, needle jet and solenoid (bottom part).
| 
The economizer taken apart. The little tube on the left is screwed into the bigger one and by turning it, the hot/fresh water mix is adjusted for the water tap.
|
Hot water tap with solenoid.
| 
Steam valve.
| 
Flowmeter (=volumetric measurement device) taken apart.
| 
The pump in pieces. Did not help, coils where fried.
|
Cleaned up and ready for the hydraulics.
| 
Water leaking from the HX inlet after putting it together again.
| 
Torn off fitting that holds the needle jet for the boiler water intake. And I thought I was very careful.....
| 
The three way solenoid. Driver part only.
|